4.3-inch Rgb 480x272 Tft Normal Black Ips Sc7283 High Brightness
Tft Display
Module size: 105.5(W)* 67.2(H) * 2.9(T) mm 480 x RGB x 272 Dots Driver: SC7283
4-wire Resistive Touch Screen, WHITE LED backlight, Top view, Wide
temperature range, Transmissive polarizer, 500 NITS, RoHS Compliant
The Resistive touch panel senses a touch by measuring where contact is made on the glass. It
is independent of temperature and humidity and simple to integrate
independent of a separate controller chip.
The Transmissive polarizer is best used for displays that run with the backlight on all the
time. This polarizer provides the brightest backlight possible. If
you have a need for a bright backlight with lower power drain,
transmissive is a good choice for this TFT LCD display.
Suggestions for using LCD modules
1 .The display panel is made of glass and polarizer. As glass is
fragile. It tends to become or chipped during handling especially
on the edges. Please avoid dropping or jarring. Do not subject it
to a mechanical shock by dropping it or impact.
2 .If the display panel is damaged and the liquid crystal substance
leaks out, be sure not to get any in your mouth. If the substance
contacts your skin or clothes, wash it off using soap and water.
3 .Do not apply excessive force to the display surface or the
adjoining areas since this may cause the color tone to vary. Do not
touch the display with bare hands. This will stain the display area
and degraded insulation between terminals (some cosmetics are
determined to the polarizer).
4 .The polarizer covering the display surface of the LCD module is
soft and easily scratched.Handle this polarizer carefully. Do not
touch, push or rub the exposedpolarizers with anything harder than an HB pencil lead (glass,
tweezers, etc.). Do not put or attach anything on the display area
to avoid leaving marks on it. Condensation on the surface and
contact with terminals due to cold will damage, stain or dirty the
polarizer. After products are tested at low temperature they must
be warmed up in a container before coming in to contact with room
temperature air.
5 .If the display surface becomes contaminated, breathe on the
surface and gently wipe it with a soft dry cloth. If it is heavily
contaminated, moisten cloth with one of the following solvents -
Isopropyl alcohol - Ethyl alcohol Do not scrub hard to avoid
damaging the display surface.
6 .Solvents other than those above-mentioned may damage the
polarizer. Especially, do not use the following.
